Home Page | HygroLab 3 Set

Operation
The HygroLab 3 Set is simple to use:
1) From the keypad of the HygroLab 3, use the MENU key to select the measuring mode.
    Note: the HygroLab automatically remembers the last selected mode.
2) During measurements, all probes connected to the instrument run simultaneously. To avoid any confusion,
    turn off any unused AW-DIO probe, by pressing on the button located on top of the probe. Other probe
    models: disconnect the unused probes.

3) Place a product sample inside the sample
    holder. Put the probe on top of the sample
    holder.  

4) AwQuick or AwE mode: start the
    measurement by pressing on the ENTER key
    (keypad of the HygroLab 3)

    Example: on the bottom line of the display, the
    AwQuick mode is indicated by the letter Q,
    followed by the number 1 (for probe 1), the time
    into the measurement and the letter R
    (process is running)
5) When the measurement is ended, the display
    freezes and the instrument beeps. Two black
    rectangles appear to the left of the values and
    the letter S (bottom right) indicates that the
    process has stopped.

    If more than one probe is connected to the
    HygroLab 3, the display automatically
    switches to each probe as soon as it is done.
    The small black triangle at the top of the
    display indicates which probe is being
    displayed. 
6) When all probes are done, press the ENTER key to clear the display and to be ready for the next
    round of measurements.