Home Page | M2 Series Main Page | Contact us

red_button.gif (982 bytes) M2 Series Installation:
   Modular design simplifies installation and facilitates maintenance

Each M2 series transmitter consists of a base plate and a measurement module (electronics). The transmitters are calibrated at our factory and are shipped in an individual box for protection during shipment or storage.

Installation is a simple 2-step process:
Mount b.jpg (9027 bytes)

Step 1

The base plate is mounted and wired. Since the measurement module is not required during this part of the installation, it can be safely stored until all the work is completed.
Mount a.jpg (9327 bytes)

Step 2

Upon completion of the wiring work, the module is just snapped into the base plate and secured with the screws provided. Any module can be installed with any base plate, no special matching is required.

When it is time to re-certify calibration or if a repair is required, simply replace the HygroClip probe or the electronics module. Rehabilitated, fully calibrated and certified replacement probes and modules are available from RIC.

HygroClip Plug-in Probe

Both the HygroClip S and the base of the connector on the transmitter are marked with a dot. The locking ring is marked with 2 dots.

 

The probe can be inserted straight into the connector when all dots are aligned. When the dots are not aligned, the probe should be rotated clockwise during insertion.

After inserting the probe, turn the locking ring clockwise to secure the probe.