Home Page | M100 Series Main Page | Contact us

red_button.gif (982 bytes) M100 Series Configurations and Installation:

Probe holder mod. QMA-15 (flange with compression fitting) facilitates installation of the probe through a wall.
To avoid measurement errors, at least 200 mm (7.8") of the probe length should be immersed in the environment to be measured.
M120D / M130D / M132D

These models with integral probe can be installed in a single step.

Use probe holder mod. QMA-15 (flange with compression fitting)
to install both the probe and transmitter to the mounting wall.
M120C / M130C / M132C

On these models, the probe is separated from the transmitter enclosure by a hard-wired cable. This allows mounting the transmitter enclosure on a different surface than the probe so as to avoid excessive temperature or vibrations at the electronics.

Use probe holder mod. QMA-15 (flange and compression fitting)
to install the probe on the mounting wall.

Attach the enclosure to the probe mounting wall or to another surface, using # 6 machine screws.